Remote Programming - Ford Galaxy

-2006

1. Make sure all doors and windows are closed.

2. Turn the key in the drivers door lock, 3 times to the unlock position for at least half
a second and within a total of 5 seconds.

3. The system should now enter programming mode, this is shown by the LED illuminating continuously for the next 15 secs- during which the key
should be programmed as follows.

4. Press one of the buttons on the key and whilst holding it pressed, simultaneously press the other button 3 times.

5. Release both buttons.

6. The key should now flash 5 times and the LED in the door should also flash, six times.

2006+

1. Insert the key in the ignition.

2. Cycle the key from position 0 to II and then back to 0 four times within six seconds.

3. Leave the key in position 0 and press any button on the remote control within 10 seconds. You will receive confirmation via a chime or LED that programming has been successful.

Note: Further remote controls may be programmed at this stage.

4. Press any button on each additional remote control within 10 seconds of each other.