Ford Remote Programming Ford C Max
Warning: Uninitialized string offset 0 in /data/www/diagwiki.com/htdocs/wiki.php on line 408
Warning: Uninitialized string offset 0 in /data/www/diagwiki.com/htdocs/wiki.php on line 442
Warning: Uninitialized string offset 0 in /data/www/diagwiki.com/htdocs/wiki.php on line 454
Warning: Uninitialized string offset 0 in /data/www/diagwiki.com/htdocs/wiki.php on line 408
Warning: Uninitialized string offset 0 in /data/www/diagwiki.com/htdocs/wiki.php on line 442
2010-
- Insert the first previously programmed coded key into the ignition.
- Switch the ignition from off to on. Keep the ignition on for at least three seconds, but no more than 10 seconds.
- Switch the ignition off and remove the first coded key from the ignition.
- After three seconds but within 10seconds of switching the ignition off, insert the second previously coded key into the ignition.
- Switch the ignition from off to on. Keep the ignition on for at least three seconds, but no more than 10 seconds.
- Switch the ignition off and remove the second previously programmed coded key from the ignition.
- After three seconds but within 10 seconds of switching the ignition off and removing the previously programmed coded key, insert the new unprogrammed key into the ignition.
- Switch the ignition from off to on. Keep the ignition on for at least six seconds.
- Remove the newly programmed coded key from the ignition.
If the key has been successfully programmed it will start your vehicle and operate the remote entry system (if the new key is an integrated keyhead transmitter).
If programming was not successful, wait 10 seconds and repeat Steps 1 through 8. If you are still unsuccessful, take your vehicle to your authorized dealer.