Remote Programming - Ford Focus

2000-2006

1. Turn the ignition from OFF to RUN 4 times within 6 seconds.

2. Turn the ignition OFF. The system will chime to confirm programming mode.

3. Within 20 seconds, press any button on first keyless remote.
The system will chime once to confirm programming.

4. Within 20 seconds, press any button on second keyless remote.
System will chime once to confirm programming.

5. Turn ignition to RUN to exit programming mode.

2007

Obtain all remote transmitters for this vehicle.

1. Fasten seat belts and close all doors.

2. Turn ignition from OFF to RUN 4 times within 6 seconds, with the 4th time ending in RUN. (Off is the position where you can remove your key, RUN is the position just shy of starting your car).

3. Turn ignition to OFF. Acoustic signal will sound to confirm programming mode.

4. Within 10 seconds, press and hold any button on the first keyless remote. Wait for acoustic sound and warning lamp to flash (confirming programming) then release button on remote. Wait 2 seconds but within 10 seconds Repeat step 4. for all other remotes. If you only have one remote then continue to step 5.

5. Turn ignition to RUN or wait 10 seconds to end programming mode.

2008-2010

1. Turn ignition from OFF to RUN 8 times within 10 seconds, with the 8th time ending in
RUN. Door locks will cycle to confirm programming mode.

2. Within 20 seconds press any button on first keyless remote. Door locks will cycle
to confirm programming.

3. Within 20 seconds, press any button on second keyless remote. Door locks will
cycle again to confirm programming.

4. Turn ignition to OFF. Locks will again cycle to indicate end of programming mode.

2010-

1. Insert the key in the ignition.

2. Cycle the key from position 0 to II and then back to 0 four times within six seconds.

3. Leave the key in position 0 and press any button on the remote control within 10 seconds. You will receive confirmation via a chime or LED that programming has been successful.

Note: Further remote controls may be programmed at this stage.

4. Press any button on each additional remote control within 10 seconds of each other.