Remote Programming - Ford Fiesta
Table of Contents

-1996

1. Turn Ignition switch to Position I and back to 0 as soon as the PATS LED in the clock lights (The system is now ready for programming, to a maximum time limit of 30 seconds).

2. Remove Key from Ignition, hold the FOB towards the Interior Light, and press and hold the Single Arrow. Wait until the light on the Key flashes, then press the Double Arrow 3times, release the Single Button

3. Both LEDs (Key & Clock) should flash to acknowledge programming is successful

4. To exit learn Mode, turn Ignition to II and then 0

5. A Maximum of 4 Remotes are possible

1996-2008

1. Insert Key and turn to II, then Turn Key from II to I and back to II four times within 3 seconds

2. The PATS LED should light. Turn Key to Position 0.

3. Press the Unlock button and keep it pressed until the PATS LED flashes 4 times.

4. Add additional fobs the same way.

Turn to II and back to 0 to end.

2008-

1. Turn the ignition key from position 0 to position II four times within six seconds.

2. Turn the ignition to position 0. A tone sounds to indicate that it is now possible to program a remote control.

Note: If a tone does not sound, repeat step 1, this time turning the ignition key from position 0 to position II 8 times within 10 seconds, ending in position 0. A tone sounds to indicate that it is now possible to program a remote control.

3. Press any button on a new remote control within 10 seconds. A tone will sound as confirmation.

4. Repeat step three within 10 seconds for each new remote control. Do not remove the key from the ignition when pressing the button on the remote control.

5. Switch the ignition back on (position II) or wait for 10 seconds without programming another remote control to end the key programming. Only the remote controls which you have just programmed are now able to lock and unlock your vehicle.